Maricopa County, AZ

Hackett House

Permit ID: FD-00021

Permit Type: E & D

23 W 4th St Tempe 85281

*PRIORITY VIOLATION is a major violation that directly contributes to increasing the risk of foodborne illness or injury.
NA means not available. See detailed inspection reports for additional information.
Grade
Priority Violation *
Cutting Edge Participant
B
1

Violation Description

Violation Comments

Correct By
14
Food-contact surfaces: cleaned & sanitized
PRIORITY VIOLATION-4-501.114, P: Manual and Mechanical Warewashing Equipment, Chemical Sanitization- Temperature, pH, Concentration and Hardness. For a permanent fix to this violation, check out these simple tools in our Active Managerial Control Toolbox, made especially for you. https://www.maricopa.gov/4574/AMC-Toolbox---Food-Contact-Surfaces. Observed 0 ppm bleach after the final rinse in the mechanical dishwasher. A service call was made at the time of inspection. Use your three compartment sink for the cleaning and sanitizing of food contact surfaces until the unit is repaired to sanitize at 50-100 ppm bleach.
Corrected At Time Of Inspection
Inspection Comments

This establishment received an B Grade and had 1 Priority, 0 Priority Foundation and 0 Core violations on this inspection. No County legal action will result from this inspection. Inspection Rights were reviewed with Gail E. at the time of inspection. Report was emailed.


Definitions
Priority violation is a major violation that directly contributes to increasing the risk of foodborne illness or injury.
e.g. - Food employees do not properly wash hands when required
Priority foundation violation is a minor violation that does not directly contribute to an increased risk of foodborne illness but failure to correct this violation may lead to the occurrence of a priority violation.
e.g.- Hand washing soap and paper towels not available at hand wash sink (may lead directly to food employees not properly washing hands when required)
Core violation is a minor violation that relates to general maintenance and sanitation.
e.g. -No sign reminding employees to wash hands
Verification Visits are inspections of establishments enrolled in the MCESD Cutting Edge Program, which requires an enhanced food safety program and ongoing demonstration of active managerial control. Verification Visit inspections found in compliance with Cutting Edge program requirements receive an “A” grade.
The matrix below has been used to grade food inspections under the voluntary grading system starting on October 14, 2011.