*PRIORITY VIOLATION is a major violation that directly contributes to increasing the risk of foodborne illness or injury.
NA means not available. See detailed inspection reports for additional information.
NA means not available. See detailed inspection reports for additional information.
Grade
Priority Violation *
Cutting Edge Participant
06
Hands clean & properly washed
PRIORITY VIOLATION-2-301.12, P: Cleaning Procedure. For a permanent fix to this violation, check out these simple tools in our Active Managerial Control Toolbox, made especially for you. https://www.maricopa.gov/4573/AMC-Toolbox---Handwashing. Observed employee wash hands for 6 sec. Discussed proper handwashing procedure with employee and person in charge at time of inspection. Handwashing is a critical factor in reducing fecal-oral pathogens that can be transmitted from hands to RTE food as well as other pathogens that can be transmitted from environmental sources. Many employees fail to wash their hands as often as necessary and even those who do may use flawed techniques.
Corrected At Time Of Inspection
20
Proper cold holding temperatures
PRIORITY VIOLATION-3-501.16(A)(2) and (B), P: Time/Temperature Control for Safety Food, Cold Holding. For a permanent fix to this violation, check out these simple tools in our Active Managerial Control Toolbox, made especially for you. https://www.maricopa.gov/4576/AMC-Toolbox---Cold-Holding. Observed cut lettuce in plastic Tupperware in the top part of pre-unit above chill line with internal temp of 57F. Person in charge discarded cut lettuce at time of inspection. Bacterial growth and/or toxin production can occur if time/temperature control for safety food remains in the temperature "Danger Zone" of 5oC to 57oC (41oF to 135oF) too long. Up to a point, the rate of growth increases with an increase in temperature within this zone.
Corrected At Time Of Inspection
22
Time as a public health control: procedures & record
Priority Foundation-3-501.19 (A1, B2, C2-3), Pf: Time as a Public Health Control; Documentation. For a permanent fix to this violation, check out these simple tools in our Active Managerial Control Toolbox, made especially for you. https://www.maricopa.gov/4125/Food-SafetyOperator-Resources. 1st consecutive violation. Observed croissants with ham and cheese, and cooked hot dogs being held as time without any time stamp. Person in charge time stamped these products at time of inspection. Discussed importance of time stamping foods being held as time with person in charge.
26
Toxic substances properly identified, stored, and used
PRIORITY VIOLATION-7-204.11, P: Sanitizers, Criteria-Chemicals
Observed establishment using lemon scented bleach for sanitizing at 3 comp sink and in all sanitizing buckets. Person in charge will go out and get new bleach this afternoon.
Priority Foundation-7-202.12 (C), Pf: Conditions of Use; Pesticides by certified applicator
Observed cans of Raid in the office. Raid was removed and discarded by person in charge. Pest control shall only be done by a licensed pest control company.
Correct Prior To Reinspection
Inspection Comments
This establishment received a(n) D Grade and had 3 Priority, 2 Priority Foundation and 0 Core violations on this inspection. No County legal action will result from this inspection.
Definitions
Priority violation is a major violation that directly contributes to increasing the risk of foodborne illness or injury.
e.g. - Food employees do not properly wash hands when required
Priority foundation violation is a minor violation that does not directly contribute to an increased risk of foodborne
illness but failure to correct this violation may lead to the occurrence of a priority violation.
e.g.- Hand washing soap and paper towels not available at hand wash sink (may lead directly to food employees not properly
washing hands when required)
Core violation is a minor violation that relates to general maintenance and sanitation.
e.g. -No sign reminding employees to wash hands
Verification Visits are inspections of establishments enrolled in the MCESD Cutting Edge Program, which requires an enhanced
food safety program and ongoing demonstration of active managerial control. Verification Visit inspections found in compliance
with Cutting Edge program requirements receive an “A” grade.
The matrix below has been used to grade food inspections under the voluntary grading system starting on October 14, 2011.
