First walk through with one of the owners. The following items were discussed: 1). Ice machine can be moved to the front service area. This way an additional hand wash sink will not be required. Drain will need to be rigid and led to the floor sink under the three compartment sink. Make sure to follow gravity flow, properly brace and keep an inch air gap at the sink. 2). Only the walls with sinks require a more durable finish like FRP. Storage area and non-wet wall can be painted (semi-gloss) dry wall. 3) Ceiling throughout is washable. 4). Wilkins Reduced Pressure Zone valve was on site and will be installed upstream of the RP system. Valve will require a hub drain and testing and certification before final inspection. 5) Rubber or Vinyl coved base will be installed throughout. It is suggested to install 6" at this point so you have a good grip on the FRP and wall when mounting. Also install along the inside of the front counter counter. 6). Sealed butcher block counter is approved for the transaction counter. Epoxy finish sounds good. 7). Please provide an additional water feed with angle stop or faucet at the mop sink for possible future chemical dispensers. 8). New mop sink faucet will need to have an integral atmospheric vacuum breaker just like the old one had. 9). Finishes are being touches up, i.e. caulking of joints, FRP corners etc. Wall throughout will need to be cleanable. 10). Clean out covers will be installed where missing. 11). If you are not going to use the floor sink in the back room then install an expandable plug in the sink drain so the the sink is sealed. 12). Please note that all exposed wood in the front counter will need to be sealed. Not discussed was the dipper well or conserve well. No County legal action will result from this inspection. E-mailed to owner including inspection rights.