Maricopa County, AZ

Corner Market

Permit ID: FD-88955

Permit Type: Retail Food Establishment

1010 W Southern Ave Tempe 85282

*PRIORITY VIOLATION is a major violation that directly contributes to increasing the risk of foodborne illness or injury.
NA means not available. See detailed inspection reports for additional information.
Grade
Priority Violation *
Cutting Edge Participant
0
Inspection Comments

Permit not Approved. Not operating at time of inspection. New owner inspection conducted with Bret. Emailed report to Bret. Please address the following prior to permit issuance: 1. Required water heater has been installed. Ensure that 110°F at all fixtures. Address the following in a 14 day period: 2. Seal raw wood used to anchor hand sink by 3 compartment sink with semi or high gloss paint. 3. Have RPs (ASSE 1013 Reduced pressure backflow) tested and certified by licensed backflow specialist. Provide certificates. 4. Provide ASSE 1022 dual check valves for tea brewers. 5. Repair exhaust fan in restroom. 6. Paint bare wood shelves in closet with sealant, semi or high gloss paint. 7. Repair damage/holes to walls in back area. Finish with semi or high gloss paint. 8. Provide 4 inch or 6 inch vinyl cove base where missing in back room. Provide 4 inch cove base along cabinets under soda counter. 9. Clean shelving and walls in walk-in. 10. Remove cardboard under shelving in walk-in. 11. Clean shelving under coffee cabinet and reseal with a rust resistant/inhibitor finish No County legal action will result from this inspection.


Definitions
Priority violation is a major violation that directly contributes to increasing the risk of foodborne illness or injury.
e.g. - Food employees do not properly wash hands when required
Priority foundation violation is a minor violation that does not directly contribute to an increased risk of foodborne illness but failure to correct this violation may lead to the occurrence of a priority violation.
e.g.- Hand washing soap and paper towels not available at hand wash sink (may lead directly to food employees not properly washing hands when required)
Core violation is a minor violation that relates to general maintenance and sanitation.
e.g. -No sign reminding employees to wash hands
Verification Visits are inspections of establishments enrolled in the MCESD Cutting Edge Program, which requires an enhanced food safety program and ongoing demonstration of active managerial control. Verification Visit inspections found in compliance with Cutting Edge program requirements receive an “A” grade.
The matrix below has been used to grade food inspections under the voluntary grading system starting on October 14, 2011.