Inspection Report

Business Name
Omni Scottsdale Resort & Spa Montelucia

Business Address
4949 E LINCOLN DR PARADISE VALLEY AZ 85253

Permit Number
FD-36661

Permit Type
Food Establishment - Eating & Drinking

Inspection Purpose
Food Routine Inspection

Inspection Date
2/25/2026

Grade
Not Participating

Priority Violation
1

Inspection Status
Re-inspection required

Violations

Violation #: 10

Description: Adequate Handwashing Sinks, Properly Supplied and Accessible

Comments:

5-205.11 - Priority Foundation: Using a Handwashing Sink-Operation and Maintenance. For a permanent fix to this violation, check out these simple tools in our Active Managerial Control Toolbox, made especially for you. https://www.maricopa.gov/4573/AMC-Toolbox: Handwashing. Addl Notes: The handwashing sink in garde manger was observed out of order at time of inspection. Water turned off. Predefined Comment: Handwash sinks must be supplied with hot water of at least 100°F, soap and an approved hand drying provision at all times. Facilities must be maintained in a condition that promotes handwashing. Other handwashing sinks available within 25 ft. Repair prior to re-inspection. Corrective Action: Correct prior to re-inspection.

Violation #: 16

Description: Food-Contact Surfaces: Cleaned and Sanitized

Comments:

PRIORITY VIOLATION-4-703.11 - Priority: Hot Water and Chemical-Methods; Sanitizing Food Contact Surfaces. For a permanent fix to this violation, check out these simple tools in our Active Managerial Control Toolbox, made especially for you. https://www.maricopa.gov/4574/AMC-Toolbox---Food-Contact-Surfaces.

Addl Notes: Observed high temperature sanitizing dish machine washing plates, utensils, and other food contact surfaces at time of inspection. Observed maximum surface temperature after a full cycle, of 154.2°F with min/max thermometer. After running the dish machine again, the maximum temperature measured at 155.1°F with min/max thermometer. PIC made service call at time of inspection. Discussed the option to switch the dish machine over to chemical sanitizing (measured at 0 PPM at time of inspection). A utensil temperature of at least 160°F must be reached during the final rinse cycle for adequate sanitation. All dishes will be sanitized in the 3-compartment sink until the dish machine is fully operational with a final rinse temperature that achieves a utensil surface temperature of 160°F, or the equipment can be switched to chemical sanitizing (50-100 ppm chlorine) with low temperature water. Corrective Action: Corrected at time of inspection.

Violation #: 18

Description: Proper Cooking Time and Temperatures

Comments:

3-401.14 (F) - Priority Foundation: Non-Continuous Cooking of Raw Animal Foods: Documentation. For a permanent fix to this violation, check out these simple tools in our Active Managerial Control Toolbox, made especially for you. https://www.maricopa.gov/4616/25575/AMC-Toolbox---Cooking. Addl Notes: Observed chef searing chicken and salmon on the flattop grill at time of inspection prior to placing product in the blast chiller to cool. In the walk in refrigerator unlabeled observed non continuous cooked chicken. Person in charge was unable to provide written policy for non-continuous cooking at time of inspection. Predefined Comment: Non-continuous cooking of raw animal proteins requires prior approval of written procedures by department. Provided guidance documents electronically. Please provide written policy for approval on non-continuous cooking by 3/9/26. Corrective Action: Correct prior to re-inspection.

Violation #: 51

Description: Plumbing Installed; Proper Backflow Devices

Comments:

5-205.15 (B) - Core: System Maintained in Good Repair; Maintained Addl Notes: Observed atmospheric vacuum breaker (AVB) missing on the mop sink by the dish machine. Predefined Comment: All plumbing must be maintained in good repair at all times. Predefined Comment: Must repair all plumbing to a state of good repair prior to next routine inspection. Corrective Action: Correct prior to next routine inspection.

Violation #: 55

Description: Physical Facilities Installed, Maintained, and Clean

Comments:

6-201.11 - Core: Floors, Walls and Ceilings-Cleanability Addl Notes: Observed multiple ceiling tiles missing above the blast chiller. Predefined Comment: All floors, walls, and ceilings must be maintained and repaired such that it is smooth and easily cleanable. Repair physical facility prior to next routine inspection. Predefined Comment: Physical facility must be maintained in good repair at all times. Repair physical facility prior to next routine inspection. Corrective Action: Correct prior to next routine inspection.

Comments/Details

Predefined Comment: No County legal action will result from this inspection.

"A" for Food Safety

Through our grading system, Maricopa County Environmental Services Department provides at-a-glance indications of how food establishments perform during food safety inspections. This system is designed to grade food establishments in terms of food safety requirements and provide recognition to those who choose to participate.

How does it work?

The issuance of grade cards to food establishments is based on voluntary participation. The person in charge, who is present during the inspection, will be asked whether they would like to participate in the Grading System. This will be decided prior to each inspection. If an establishment does not participate in the Grading System, Not Participating or NP will appear on the inspection report, and the inspection will still occur. If an establishment does participate, a grade of A, B, C, or D will be determined at the conclusion of the inspection using the Grading System chart below. Participating establishments will then be provided with a grade card that can be posted in the establishment. The status of the establishment’s grade will also appear on the Restaurant Ratings page of the department’s website.

How can I determine the grade?

The Grading System chart can be used to determine grades earned for establishments that do not participate. Grades are determined by the number of Priority and Priority Foundation violations received at the time of inspection. Violation types are defined in general terms below.

Definitions

Priority Violation: Major violation that directly contributes to increasing the risk of foodborne illness or injury (e.g. Food employees do not properly wash hands when required).
Priority Foundation Violation: Minor violation that does not directly contribute to an increased risk of foodborne illness but failure to correct this violation may lead to the occurrence of a priority violation. For example, hand washing soap and paper towels not available at hand wash sink (may lead directly to food employees not properly washing hands when required).
Core Violation: Minor violation that relates to general maintenance and sanitation (e.g. No sign reminding employees to wash hands).
Cutting Edge Program: All county food-related establishments can partner with Maricopa County to implement a proactive approach to reducing foodborne illness risk factors by implementing food safety systems that include policies, training, and verification processes. Partners enrolled in the Cutting Edge Program receive an A+ when an A is earned.

Grading System The matrix below is used to grade food inspections under the voluntary grading system.
Violation Category	Grade A	Grade B	Grade B	Grade B	Grade B	Grade B	Grade B	Grade B	Grade C	Grade C	Grade C	Grade C	Grade C	Grade C	Grade D	Grade D
Priority	0	0	0	0	0	1	1	1	0	1	1	2	2	2	more than 2	more than 3
Priority Foundation	0	1	2	3	4	0	1	2	5	3	4	0	1	2	more than 3	more than 0

Any legal action for a pattern of non-compliance or permit suspension results in a D.