Inspection Report

Business Name
Silverleaf Club
Business Address
18701 N SILVERLEAF DR SCOTTSDALE AZ 85255
Permit Number
FD-74228
Permit Type
Food Establishment - Eating & Drinking
Inspection Purpose
Food Routine Inspection
Inspection Date
9/10/2026
Grade
Not Participating
Priority Violation
3
Inspection Status
Completed

Violations

Violation #: 16

Description: Food-Contact Surfaces: Cleaned and Sanitized

Comments:

PRIORITY VIOLATION-4-501.114 (A-E) - Priority: Manual and Mechanical Warewashing Equipment, Chemical Sanitization- Temperature, pH, Concentration and Hardness. For a permanent fix to this violation, check out these simple tools in our Active Managerial Control Toolbox, made especially for you. https://www.maricopa.gov/4574/AMC-Toolbox---Food-Contact-Surfaces.

Addl Notes: Observed low temperature chlorine sanitizing dish machine being used to wash glassware at the main bar. Final rinse chlorine sanitizer was observed at 0 PPM. Final rinse chlorine sanitizer concentration shall measure between 50-100 PPM. After further inspection it was determined that 2 jugs of detergent were attached to the dish machine. After instruction the bartender replaced one of the detergent supplies with sanitizer. Dish machine was tested again and santizier concentration measured at 50PPM. Corrective Action: Corrected at time of inspection.

PRIORITY VIOLATION-4-703.11 - Priority: Hot Water and Chemical-Methods; Sanitizing Food Contact Surfaces. For a permanent fix to this violation, check out these simple tools in our Active Managerial Control Toolbox, made especially for you. https://www.maricopa.gov/4574/AMC-Toolbox---Food-Contact-Surfaces.

Addl Notes: In the kitchen observed high temperature sanitizing dish machine being used to sanitize pans and plates. Maximum water temperature observed at 151.3°F Maximum water temperature observed at 155.5°F after running the dish machine one more time. Predefined Comment: When food-contact surfaces are being sanitized with hot water in a dish machine, the surface temperature must reach at least 160°F as measured by an irreversible registering temperature measuring device to destroy pathogens that may remain on such surfaces after cleaning. Service request made at time of inspection by the PIC. All food contact surfaces will be sanitized in the three-compartment sink until the high temperature dish machine is repaired. Corrective Action: Corrected at time of inspection.

Violation #: 23

Description: Proper Date Marking and Disposition

Comments:

PRIORITY VIOLATION-3-501.18 - Priority: Ready-To-Eat Time/Temperature Control for Safety Food, Disposition. For a permanent fix to this violation, check out these simple tools in our Active Managerial Control Toolbox, made especially for you. https://www.maricopa.gov/4125/Food-SafetyOperator-Resources.

Addl Notes: In the walk in refrigerator near the office observed cooked peppers dated 8/23 and cooked Calabrian peppers dated 8/23. In the server station reach in refrigerator observed cooked garlic dated 8/26. Predefined Comment: RTE/TCS foods requiring date marking must be date marked within 24 hours and sold or discarded after 7 days (including the day it was made as day 1). Predefined Comment: All RTE/TCS foods past 7 days of preparation were discarded by PIC at the time of inspection Corrective Action: Corrected at time of inspection.

Comments/Details


Predefined Comment: No County legal action will result from this inspection.
Discussed 4 hour TPHC/ cold holding for butter. Discussed soda gun nozzle cleaning frequency.

"A" for Food Safety

Through our grading system, Maricopa County Environmental Services Department provides at-a-glance indications of how food establishments perform during food safety inspections. This system is designed to grade food establishments in terms of food safety requirements and provide recognition to those who choose to participate.

How does it work?

The issuance of grade cards to food establishments is based on voluntary participation. The person in charge, who is present during the inspection, will be asked whether they would like to participate in the Grading System. This will be decided prior to each inspection. If an establishment does not participate in the Grading System, Not Participating or NP will appear on the inspection report, and the inspection will still occur. If an establishment does participate, a grade of A, B, C, or D will be determined at the conclusion of the inspection using the Grading System chart below. Participating establishments will then be provided with a grade card that can be posted in the establishment. The status of the establishment’s grade will also appear on the Restaurant Ratings page of the department’s website.

How can I determine the grade?

The Grading System chart can be used to determine grades earned for establishments that do not participate. Grades are determined by the number of Priority and Priority Foundation violations received at the time of inspection. Violation types are defined in general terms below.

Definitions

Priority Violation
Major violation that directly contributes to increasing the risk of foodborne illness or injury (e.g. Food employees do not properly wash hands when required).
Priority Foundation Violation
Minor violation that does not directly contribute to an increased risk of foodborne illness but failure to correct this violation may lead to the occurrence of a priority violation. For example, hand washing soap and paper towels not available at hand wash sink (may lead directly to food employees not properly washing hands when required).
Core Violation
Minor violation that relates to general maintenance and sanitation (e.g. No sign reminding employees to wash hands).
Cutting Edge Program
All county food-related establishments can partner with Maricopa County to implement a proactive approach to reducing foodborne illness risk factors by implementing food safety systems that include policies, training, and verification processes. Partners enrolled in the Cutting Edge Program receive an A+ when an A is earned.
Grading System The matrix below is used to grade food inspections under the voluntary grading system.
Violation Category Grade A Grade B Grade B Grade B Grade B Grade B Grade B Grade B Grade C Grade C Grade C Grade C Grade C Grade C Grade D Grade D
Priority 0 0 0 0 0 1 1 1 0 1 1 2 2 2 more than 2 more than 3
Priority Foundation 0 1 2 3 4 0 1 2 5 3 4 0 1 2 more than 3 more than 0

Any legal action for a pattern of non-compliance or permit suspension results in a D.